5-in-1 Face Skin EMS RF EMS Beauty instrument Facial Mesotherapy Electroporation Rejuvenation Women face care tool Eye care tool

Start on

1. Power on, so the light flashes three times, and then it goes to sleep
2. Long press the KEY2 button (over 1.5S) to wake up the chip/shut down, the LED light on mode refers to the prototype; after 5 minutes of power on, there is no operation, all the LED lights are off, and the chip automatically enters the sleep state.
3. Working mode, the default is the cleaning mode when starting up, the chip has a memory function, and the working mode before turning on the next time is the mode before shutting down. When it is turned on again, press the KEY button to switch the working mode: clean export-warm import-eye care-EMS mode-red light mode-blue light mode, which can be switched cyclically. Each mode automatically enters sleep mode after working for 5 minutes and stops all output.

Function

1. Clean export mode: the corresponding mode LED light flashes and the heating plate starts to heat up. When the face contact plate touches the human body, the motor starts to vibrate;
2. The warm introduction mode and eye care mode are the same as above;
3. EMS mode: the LED light of the corresponding mode flashes, and the motor starts to vibrate when the face contact plate touches the human body;

4. Red light mode, the corresponding mode LED light flashes, the red LED light group on the sensor plate is on, when the face contact plate touches the human body, the motor starts to vibrate;

5. Blue light mode, the corresponding mode LED light flashes, the blue LED light group on the sensor plate is on, when the face contact plate touches the human body, the motor starts to vibrate;

6. Gear switch, the default is high gear at boot, the current gear LED is on, and the light is switched by pressing the KEY1 button, high-low-medium-high, cycle switching
7. Power indicator, the corresponding power indicator flashes after booting. When the power exceeds 4V, D21 flashes; when it exceeds 3.8V and falls below 4V, D22 flashes; when it exceeds 3.4V and falls below 3.8V, D23 flashes; when it is below 3.4V , D24 light flashes.
8. Low battery indicator: When the voltage is lower than 3.2V, the four battery indicator lights flash 3 times at the same time, and then enter the sleep state (refer to the actual measurement of the prototype)
4. Charging status: When the USB is plugged in for charging, the power indicator marquee is on, and the four power indicators are on when fully charged.

Package 1(NO Detail Box)

1 * Device
1 * Manual
1 * Charging Cable

Package 2(With Detail Box)

1 * Device
1 * Manual
1 * Charging Cable
1 * Detail Box